Removing and installing right rear window wiper motor, vehicles with rear wing doors — AUDI
Removing and installing right rear window wiper motor, vehicles with rear wing doors on Audi: 12 steps.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Transporter T5 (7H), VW Transporter T5 (7J), VW Transporter T6 (7E), VW Transporter T6 (7F)
Don't miss
- Make sure that seal (1) is properly seated in installation aperture of wing door.
📋 Procedure
- Remove rear window wiper arm .
- Remove lower rear wing door trim General body repairs, interior70Door trims;.
- Release and disconnect connector (1) on rear window wiper motor.
- Pull off hose connecting piece (2) for rear window washer system.
- Remove securing bolts (3).
- Remove rear window wiper motor (4).
- If necessary, unbolt rear window wiper motor from bracket (arrows).
- Make sure that seal (1) is properly seated in installation aperture of wing door.
- ⚠ Before inserting rear right wing door window wiper motor V93, moisten rear window wiper arm shaft with lubricant polyethylene glycol. — Insert rear right wing door window wiper motor V93.
- Screw in and tighten securing bolts (3) for rear right wing door window wiper motor V93. Specified torque: Assembly overview - rear window wiper system, vehicles with rear wing doors.
- Install lower rear wing door trim General body repairs, interior70Door trims;.
- Install rear window wiper arm .
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Renewing left-hand flange shaft oil seal
- Renewing oil seals for torque converter bellhousing
- Renewing oil seals for drive pinion shaft
- Renewing ATF breather
- Removing and installing vibration damper on transfer gearbox
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.