Removing and installing reversing camera system control unit J772, RS 5 Cabriolet — AUDI

🧭 Before you start

Fits: Audi A5 Cabriolet (8F)

📋 Procedure

1. Switch off ignition and all electrical equipment and remove ignition key.
2. Open right storage compartment in luggage compartment.
3. Release clip (arrow) and remove parking aid control unit J446(1) from mounting frame.
4. Place parking aid control unit J446 to one side with wiring (2 … 4) attached.
5. Remove nuts (1 … 3) and bolt (5).

6. Disengage mounting frame (4) from studs and swivel it to one side and towards luggage compartment.
7. Release and unplug connectors (3) and (4) at reversing camera system control unit J772.
8. Unscrew nuts (arrows).
9. Swivel bracket (1) with reversing camera system control unit J772(2) into luggage compartment.
10. Remove bolts (arrows) on bracket (2).
11. Remove reversing camera system control unit J772(1) from bracket (2).
12. Install in reverse sequence of removal.
13. Perform calibration .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing exhaust gas temperature sender 3G495 · 1 torque figures
• Checking return flow rate of injectors at starter cranking speed
• Removing and installing engine control unit J623 – Audi
• Renewing oil seal (left-side) – Audi Q7
• Removing and installing drive chain and chain tensioner for oil pump