Removing and installing reversing camera system control unit J772 — AUDI
Removing and installing reversing camera system control unit J772 on Audi: 12 steps, 2 torque figures.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A5 Cabriolet (8F)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 3 Nm (2.2 lb-ft) | Unscrew bolts (arrows |
| 8 Nm (5.9 lb-ft) | Unscrew nuts (1) and (3 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Switch off ignition and all electrical equipment and remove ignition key.
- Open right storage compartment in luggage compartment.
- Release clip (arrow) and remove parking aid control unit J446(1) from mounting frame.
- Place parking aid control unit J446 to one side with wiring (2 … 4) attached.
- Remove nuts (1 … 3) and bolt (5).
- Disengage mounting frame (4) from studs and swivel it to one side and towards luggage compartment.
- Remove nuts (1) and (3) from bracket (2) and swivel bracket (2) to one side and towards luggage compartment.
- Release and unplug connectors (4) and (5) at reversing camera system control unit J772.
- Remove bracket with reversing camera system control unit J772 from luggage compartment.
- Press tab (2) on bracket (1) in direction of (arrow) and pull reversing camera system control unit J772(3) out of bracket (1).
- Install in reverse sequence of removal.
- Perform calibration .
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Connecting the adapter wiring harness at TV tuner R78
- Connecting test box V.A.G 1598 A with adapter cable (47-pin) V.A.G 1598/33 to ABS with EDL control unit J104
- Checking voltage supply of secondary air pump motor V101 and secondary air pump motor 2 V189
- Checking multi-function switch F125 with 8-pin connector
- Checking relay for fuel cooling pump V166 – Audi 3.3 TDI AKF
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.