TorqFix

Removing and installing rear window wiper motor: Audi A3

Step-by-step removing and installing rear window wiper motor for the Audi A3: 11 steps. What to remove, in what order, and what to check after.

Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.

11 steps

🧭 Before you start

Fits: Audi A3 (8P, 2003–2012)

📋 Procedure

  1. Remove wiper arm .
  2. Remove trim at bottom of rear lid 70.
  3. Unplug electrical connector (2).
  4. Disconnect washer fluid hose (1) from connecting pipe for washer jet.
  5. Remove nuts (arrows) and detach wiper motor.
AUDI? Steps differ between engine variants — check this job against your exact car before you commit to it. Check my car — free →
  1. Carefully insert rubber seal into hole in rear window.
  2. Switch on ignition.
  3. Actuate rear wiper and allow wiper motor to move to end position.
  4. Switch off ignition.
  5. Install trim at bottom of rear lid 70.
  6. Adjust wiper arm .

Who makes these pages, and how

TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.

The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.

Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.

Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com

The story behind TorqFix →

Workshop data on this page last updated 20 Sep 2026.