Removing and installing rear side panel trim, hardboard-type, Transporter — AUDI

🧭 Before you start

Fits: VW Transporter T5 (7H), VW Transporter T5 (7J), VW Transporter T6 (7E), VW Transporter T6 (7F)

• Renewed: as necessary

Don't miss

• Before installing, check spreader rivets (3) for damage and renew as necessary.

📋 Procedure

1. Remove seats in 2nd row.
2. Remove seats in 3rd row.
3. Remove belt end fitting from seat belt in 3rd seat row .
4. Remove belt relay fitting from seat belt in 3rd seat row .
5. Unscrew clamping pin (2) (Qty. 11) using 3 mm hexagon key.

6. Pull out spreader rivet (3) (Qty. 11).
7. Release trim (1) in upper area.
8. Press down locking hook of trim (arrow) and take out trim from panel.
9. Guide seat belt through panel. [Note: Before installing, check spreader rivets (3) for damage and renew as necessary.]
10. Install in reverse order of removal.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing temperature sensor G18
• Removing and installing front turn signal bulb M5/M7, halogen headlights - vehicles from model year 2012 onwards, USA vehicles from model year 2013 onwards
• Removing and installing inner tail light cluster – Audi A5
• Removing and installing reversing light bulb M76/M77 – Audi A5
• Removing and installing roof aerial, Coupé – Audi A5