Removing and installing roof aerial, Coupé: Audi A5

🧭 Before you start

Fits: Audi A5 (8T, 2007–2016)

Don't miss

• Ensure that seal is seated properly.

📋 Procedure

1. Switch off all electrical equipment.
2. Remove ignition key.
3. Remove C-pillar trim (left and right) General body repairs, interior70Passenger compartment trim panels; Removing and installing C-pillar trim.
4. Remove headliner completely General body repairs, interior70Roof trim; Removing and installing moulded headliner, and lay it down on dash panel.
5. Release and unplug connectors (1), (2) and (3) to aerial wires.

6. Remove aerial wires up to radio, telephone and navigation system aerial R52(arrows).
7. Unscrew nut (4).
8. Detach radio, telephone and navigation system aerial R52(5) from roof.
9. Guide in aerial wires through roof opening and carefully fit radio, telephone and navigation system aerial R52 onto roof.
10. Ensure that seal is seated properly.
11. Install in reverse sequence of removal.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing steering column adjustment switch E167
• Removing and installing fuse holder FSF – Audi Q7
• Removing and installing drive plate with roller bearing – Audi
• Removing and installing air conditioner compressor, vehicles with 6-cyl. engine
• Removing and installing holder for rear air distribution flap control motor V427