Removing and installing rear seat backrest contact switch - "High" outer seat in 2nd row — AUDI

🧭 Before you start

Fits: Audi Q7 (4M, 2015–)

Don't miss

• The release lever must release the switch.

📋 Procedure

1. Remove seat rail trim (sill side) .
2. Unscrew bolts (5) and swivel bracket (4) for trim to one side.
3. Release clip (3).
4. Remove bolt (2).
5. Detach rear seat backrest contact switch (1) and unplug electrical connector.

6. Position switch so that rocker switch is approximately vertical next to release lever (1).
7. Tighten bolt (2).
8. ⚠ Risk of injury: take care that your fingers do not get trapped when closing the lock for the seat folding mechanism.Use a screwdriver or other suitable tool to close the lock for the seat folding mechanism. — Use a screwdriver or other suitable tool to close the lock for the seat folding mechanism (arrow) on both sides.
9. The release lever must release the switch.
10. If necessary, loosen bolt (2) and adjust position of switch (3) accordingly.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Exploded view - sliding sunroof · 2 torque figures
• Vehicles with digital radio R147 · 2 torque figures
• Assembly overview - turbocharger · 4 torque figures
• Exploded view - cylinder block (pulley end) · 4 torque figures
• Exploded view - mechatronic unit · 4 torque figures