5 - Removing and installing third rear three-point seat belt (fixed backrest, rear) — AUDI

🧭 Before you start

Fits: Audi A6 C5 (4B)

📋 Procedure

1. Remove seat bench (rear) .
2. Remove backrest (rear) .
3. Unscrew bolt (2).
4. Unclip belt guide trim (8).
5. Remove rear shelf (on vehicles with fixed backrest, rear) .

6. If necessary, unplug electrical connector (9) at belt tensioner.
7. Remove bolt (5) (1x).
8. Remove belt tensioner (1).
9. With belt tensioner (1) removed, screw in bolt (5) one to two turns.
10. Fit belt tensioner (1) with bolt (5) in mountings and press belt tensioner (1) forwards as far as it will go.
11. Tighten bolt (5).
12. Tighten bolt (2).
13. Thread belt (10) into latch trim (3) ensuring that it is not twisted.
14. Guide belt (10) around latch trim (3) in direction of arrow (A) and insert in the direction of arrow (B).
15. Plug in electrical connector (9).
16. Clip triggering wire of belt tensioner into retainer(6), keeping the wire taut.
17. Clip belt guide (8) into rear shelf (7).
18. On vehicles with belt tensioners, check belt buckle sensors .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Checking fuel system pressurisation pump G6 - TDI vehicles
• Removing and installing desiccant bag/desiccant cartridge · 1 torque figures
• Adjusting rear lid - Avant – Audi A4 B8 · 2 torque figures
• Removing and installing piston for rear brake caliper – Audi
• Removing and installing turbocharger 1 control unit J724 - vehicles with 2.7 ltr. engine up to 12.2005 and 3.0 ltr. engine · 1 torque figures