Removing and installing "“radio and navigation system 2”" with multifunction display (MFD) — AUDI

🧭 Before you start

Fits: VW Caddy III (2K, 2004–2015); platform code 2C0

• Special tools named: locking bar

Don't miss

• Danger of damage to component surfaces.When using leverage tools, mask the component in the area of view with commercially available adhesive tape. — Using removal wedge3409, carefully lever out centre console cover (arrows).

📋 Procedure

1. Remove any CDs left in the unit Operating manual.
2. Switch off ignition and all electrical loads, and pull out ignition key.
3. ⚠ Danger of damage to component surfaces.When using leverage tools, mask the component in the area of view with commercially available adhesive tape. — Using removal wedge3409, carefully lever out centre console cover (arrows).
4. Unscrew securing bolts (arrows) from radio navigation system.
5. Pull radio navigation system out of installation slot until you can access connectors at rear of unit.

6. Press locking mechanism of connector together in (direction of arrow).
7. Swing locking bar upwards in (direction of arrow) and disconnect connector.
8. Release and disconnect connectors from aerial connections (arrows).
9. Connect connectors to radio navigation system and engage them.
10. ⚠ Risk of damage to display and operating keys!When inserting the radio navigation system into the installation slot by pressing against the display or operating keys, the unit could become damaged.When inserting the radio navigation system never press against the display or operating keys. — Push radio navigation system straight into dash panel.
11. Secure radio navigation system with the 4 securing bolts (arrows).
12. Remount centre console cover.
13. Check coding of radio navigation system and re-code if necessary .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing intake manifold (bottom section, right-side) - vehicles with engine codes BUG and BUN
• Removing tank filler flap locking motor (V 155) up to vehicle identification number 4L 9-014 900 · 1 torque figures
• Removing and installing airbag igniter on driver side N95
• Removing and installing key operated switch to deactivate front passenger side airbag E224
• Removing and installing control unit for front display and information control panel J523, basic (up to week 21/09)