Removing and installing radio navigation system with monochrome display — VW

Removing and installing radio navigation system with monochrome display
Note
The part number for the complete radio/navigation system is printed on a sticker on the radio/navigation system housing!
If a radio navigation system from one vehicle is fitted into another vehicle, it is essential that the part number of the replacement unit is the same as that of the unit previously installed. Otherwise faults will occur in navigation because the steering angle sensor setting in the radio navigation system will not be compatible with the vehicle.
If the radio navigation system is renewed or exchanged, adapt the impulses of the ABS speed sensors and the tyre circumference to quickly improve the accuracy of the radio navigation system, Adapting navigation system components
Chapter
.
Special tools and workshop equipment required
Radio release tool
T10057
(only for Multivan vehicles with convenience dash panel)
Note
Obtain code number from the customer before removing the radio navigation system. If the radio navigation system has to be renewed, it is essential to deactivate the anti-theft coding system
Chapter
. The customer must be informed of the new code.
Removing:
Remove any CDs left in the unit
Operating manual
.
Switch off ignition and all electrical loads, and pull out ignition key.
Slide the
radio release tools
T10057
into the release slots
arrows
until they engage.
Top L - top and bottom on left
Top R - top and bottom on right
Using the grip rings of the release tools, pull radio navigation system out of dash panel until connectors at rear are accessible.
Release and disconnect all connectors.
Press locking tabs
arrow
and pull release tool out forwards.
Installing:
Install in the reverse order of removal. When doing this, note the following:
Connect connectors to radio navigation system and engage them.
Caution
Risk of damage to display and operating keys!
When inserting the radio navigation system into the installation slot by pressing against the display or operating keys, the unit could become damaged.
When inserting the radio navigation system never press against the display or operating keys.
Slide radio navigation system straight into dash panel, until it engages in mounting frame.
Check coding of radio navigation system and re-code if necessary. In this case coding is carried out via the radio function of the radio navigation system, Adapting components - radio navigation system with monochrome display
Chapter
.