Removing and installing radiator fan V7 (right side): Audi A6 C5 (AJK, APB, ARE, ASJ, …)

🧭 Before you start

Fits: Audi A6 C5 (4B)

Don't miss

• Risk of injury as the radiator fans may start up automatically.Unplug electrical connectors before starting to work in the area of radiator cowl. — Unplug black connector and move wiring to radiator fan V7 clear.
• Fit all cable ties in the original positions when installing.

🔧 Engine codes this applies to

📐 20 workshop diagrams for AJK

Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.

📋 Procedure

1. Release fasteners (arrows) and remove noise insulation.
2. Remove front bumper 63.
3. Move lock carrier to service position 50.
4. Remove cover (arrow) at power steering fluid reservoir.
5. Remove all electrical connectors from the bracket (arrows).

6. ⚠ Risk of injury as the radiator fans may start up automatically.Unplug electrical connectors before starting to work in the area of radiator cowl. — Unplug black connector and move wiring to radiator fan V7 clear.
7. Remove bolt (1).
8. Turn radiator fan in direction of (arrow) and remove. [Note: Fit all cable ties in the original positions when installing.]
9. Install lock carrier with attachments 50.
10. Install front bumper 63.
11. Install noise insulation 50.

Other AUDI procedures

• Removing and installing radiator fan 2V177 (front) – Audi 2.7
• Removing and installing engine control unit without protective housing
• Checking solenoid valve for charge pressure control N75
• Checking hydraulic bucket tappets – Audi A6 C5
• Checking road speed signal – Audi A6 C5
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures