Removing and installing poly V-belt, vehicles with air conditioner — AUDI

🧭 Before you start

Fits: VW Caddy IV (SA, 2015–2020)

• Timing position: the crankshaft or camshaft is set and locked during this job

Don't miss

• Mark direction of rotation of poly V-belt.

🔧 Engine codes this applies to

📋 Procedure

1. If fitted, remove noise insulation General body repairs, exterior66Noise insulation; Removing and installing noise insulation.
2. Mark direction of rotation of poly V-belt.
3. To loosen poly V-belt, turn tensioner (1) in anti-clockwise direction (arrow).
4. Lock tensioner (1) in place with locking pin T10060 A.
5. Release tension from tensioner (1).

6. Remove poly V-belt. [Note: Various versions of the overrunning alternator pulley, (A) or(B), may be fitted depending on the type and version of alternator. Allocation The length of the poly V-belt must be determined according to the Electronic Parts Catalogue depending on the version of overrunning alternator pulley.]
7. Fit poly V-belt as shown in illustration.
8. Turn tensioning device (1) in anti-clockwise direction (arrow).
9. Pull out locking pin T10060 A.
10. Release tension from tensioner (1).
11. Check that poly V-belt is properly seated.
12. Start engine and check that belt runs properly.

Other AUDI procedures

• Checking function and voltage supply – Audi A1
• Checking fuel tank breather
• Removing and installing accelerator module with accelerator position sender G79/G185 · 1 torque figures
• Removing and installing coolant pipes – VW 2.0
• Checking function and voltage supply, vehicles with engine codes CWVA, CWVB, CHYA, CHYB
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures