Removing and installing particulate filter - vehicles with manual gearbox/multitronic gearbox — AUDI

🧭 Before you start

Fits: Audi A6/A7 C7 (4G, 2011–2018)

• Renewed: seals

Don't miss

• Disregard (items 2, 3).
• Renew seals, gaskets and self-locking nuts.

🔧 Engine codes this applies to

📋 Procedure

1. ⚠ When working on all parts of the exhaust system:Observe safety precautions when working on the exhaust system . — Remove plenum chamber partition panel General body repairs, exterior50Bulkhead; Removing and installing plenum chamber partition panel.
2. Remove front exhaust pipe .
3. Take electrical connectors (1, 3) out of bracket, unplug connectors and move electrical wiring clear.
4. Unplug electrical connector (2), unclip pressure differential sender G505 from bracket and move clear.
5. Detach electrical connectors (1 and 4) from bracket and unplug. [Note: Disregard (items 2, 3).]

6. Detach particulate filter. [Note: Renew seals, gaskets and self-locking nuts.]
7. Electrical connections and routing .
8. Install front exhaust pipe .
9. Secure electrical wiring to catalytic converter heater 1Z119.
10. Install plenum chamber partition panel General body repairs, exterior50Bulkhead; Removing and installing plenum chamber partition panel.
11. After renewing particulate filter, perform Adaption in Guided Functions.

Other AUDI procedures

• Removing and installing turbocharger 1 control unit J724 - vehicles with two turbochargers, manual mode
• Removing and installing pressure differential sender G505
• Filling and bleeding fuel system
• Removing and installing injector for reducing agent N474
• Exploded view - radiator cowl and radiator fans · 1 torque figures
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures