Removing and installing noise insulation - Audi RS 5: Audi A5
Step-by-step removing and installing noise insulation - Audi RS 5 for the Audi A5: 10 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A5 (8T, 2007–2016)
📋 Procedure
- Remove bolts (arrows).
- Unscrew bolts (arrows) securing wheel spoiler (front) to wheel housing liner (front) (1).
- Remove quick-release fasteners (arrows).
- Pull noise insulation (front) (1) towards rear and out of bottom section of bumper cover.
- Detach noise insulation (front).
- Remove bolt (4).
- Pull out spreader pin (1) and detach it together with fastener.
- Remove quick-release fasteners (3) at noise insulation (front).
- Remove quick-release fastener (5).
- Detach noise insulation (rear) (2).
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing shackle, vehicles with twin wheels
- Removing and installing actuator for differential lock, Crafter 4MOTION with Achleitner four-wheel drive
- Aligning propshaft, Crafter 4MOTION with Achleitner four-wheel drive
- Removing and installing selector cylinder for power take-off · 1 torque figures
- Removing and installing tank for reduction agent
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.