Removing and installing moulded headliner for passenger compartment — AUDI

🧭 Before you start

Fits: VW Transporter T5 (7H), VW Transporter T5 (7J), VW Transporter T6 (7E), VW Transporter T6 (7F)

📋 Procedure

1. Remove centre interior lights Electrical system96Lights and switches in roof headliner.
2. Remove rear interior lights Electrical system96Lights and switches in roof headliner.
3. Remove B-pillar grab handles .
4. Remove upper B-pillar trim. The belt end fittings need not be removed .
5. Remove retainers for net partition .

6. Remove upper C-pillar trim .
7. Remove upper D-pillar trim .
8. Remove rear roof end strip .
9. Remove middle and rear roof grab handles .
10. Pull air duct hose (2) off air duct (1) on moulded headliner (3)(arrow).
11. Lower rear area of moulded headliner (3) slightly and pull it to rear out of the clips.
12. Pull moulded headliner (3) to rear out of vehicle.
13. Remove the 8 clips (1) from the roof bows and insert then into the clip holders (2) (on back of moulded headliner).
14. Position passenger compartment moulded headliner in installation position and clip into the roof.
15. Further installation is performed in the reverse order of removal.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing roof aerial – Audi A6/A7 C7 · 1 torque figures
• Checking heating output - automatically controlled air conditioner
• Checking cooling output - manually controlled air conditioner
• Removing and installing pulley - Valeo air conditioner compressor
• Removing and installing air recirculation flap control motor V113 - manually controlled air conditioner (or heater without air conditioner)