Removing and installing lumbar support height adjustment motors - old version — AUDI

🧭 Before you start

Fits: Audi A6 C6 (4F, 2004–2011)

📋 Procedure

1. Remove seat .
2. Attach seat repair standVAS 6136 to engine and gearbox supportVAS 6095.
3. Attach front seat to seat repair standVAS 6136.
4. Remove backrest cover panel .
5. Remove side airbag .

6. Unplug connector (10).
7. Drill out rivets (8) (2x) on outside.
8. Disengage Bowden cable (3) from retaining plate (7) at hook (6).
9. Thread Bowden cable (3) out of support (5).
10. Unplug connector (10).
11. Drill out rivets (8) (2x) on outside.
12. Disengage Bowden cable (11) from four-way lumbar support (4) at hook (2).
13. Disengage Bowden cable (11) from retainer (1).

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Adjusting bevel box
• Removing and installing 1st, 2nd and reverse gear - exploded view
• Checking inlet camshaft control valve 1 N205 – Audi 1.8
• Removing and installing fuel gauge sender 2 G169
• Adjusting accelerator position sender G79 - right-hand drive vehicles without accelerator pedal module