Removing and installing four-way lumbar support control motors — AUDI

🧭 Before you start

Fits: Audi A4 B6/B7 (8E)

Don't miss

• When renewing control motor, four-way lumbar support must not be in an end stop position.

📋 Procedure

1. Remove backrest cover panel .
2. Unplug electrical connector .
3. Release retaining bracket and take control motor out downwards .
4. The control motor can only be installed in one position. [Note: When renewing control motor, four-way lumbar support must not be in an end stop position.]
5. Remove backrest cover panel .

6. Unplug electrical connector .
7. Release retaining bracket and lift out control motor .
8. The control motor can only be installed in one position. [Note: When renewing control motor, four-way lumbar support must not be in an end stop position.]
9. Unplug electrical connector (4).
10. Release retaining bracket (3) using a screwdriver (2) and take out control motor (1).

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Connecting fault reader V.A.G 1551 and selecting function
• Removing and installing poly V-belt for power steering pump, alternator and viscous fan · 2 torque figures
• Removing and installing poly V-belt for A/C compressor · 2 torque figures
• Removing and installing navigation/TV tuner J415 – Audi · 3 torque figures
• Removing and installing left aerial module R108 – Audi A3 · 3 torque figures