Removing and installing four-way lumbar support motors: Audi A4 B6/B7

🧭 Before you start

Fits: Audi A4 B6/B7 (8E)

📋 Procedure

1. Remove seat (see the separate procedure).
2. Attach seat repair stand VAS 6136 to engine and gearbox support VAS 6095.
3. Attach front seat to seat repair stand VAS 6136.
4. Remove backrest cover panel (see the separate procedure).
5. Unplug connector (8).

6. Drill out rivets (6) (2x).
7. Remove motor on other side in the same way.
8. Disengage Bowden cable for adjusting height of four-way lumbar support (9) at hook (1).
9. Disengage Bowden cable for four-way lumbar support (2) at retaining pin (4) and guide roller (5).
10. Take out four-way lumbar support motors (7) (2x).
11. Install four-way lumbar support motors (7) in reverse order of removal.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Checking signal from fuel gauge sender – Audi A6 C5
• Removing and installing oil filter bracket - engine code letters AFB, AKN, AKE, AYM, BAU, BCZ, BFC
• Removing and installing mechanical exhaust gas recirculation valve - engine code letters AFB, AKE, AKN, AYM, BAU, BCZ, BFC
• Assembling triple roller joint – Audi
• Connecting vehicle diagnostic, testing and information systemVAS 5051A and selecting functions