Removing and installing lateral acceleration sensor: Audi TT Mk1
Step-by-step removing and installing lateral acceleration sensor for the Audi TT Mk1: 13 steps, 2 torque figures.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi TT Mk1 (8N)
- Renewed: cable tie
Don't miss
- Make sure there is no-one in the vehicle when connecting battery. — Close doors.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 6 Nm (4.4 lb-ft) | Unscrew bolts (3) (2x |
| 7 Nm (5.2 lb-ft) | Unscrew bolts (3) (2x |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Disconnect battery earth strap/cable.
- Remove front seat .
- Remove lower (A) pillar trim .
- Unclip inner sill panel trim.
- Lift floor covering in area of lateral acceleration sensor.
- Sever cable tie (4).
- Unplug connector (2) from lateral acceleration sensor (1).
- Unscrew bolts (3) (2x). Tightening torque 6 Nm — 6 Nm (4.4 lb-ft)
- Detach lateral acceleration sensor (1).
- Replace cable tie.
- Switch on ignition.
- ⚠ Make sure there is no-one in the vehicle when connecting battery. — Close doors.
- Connect battery earth strap. [Note: After connecting battery, remember to check vehicle equipment (radio, clock, electric window lifters) in line with Workshop Manual and/or owner's manual.If airbag warning lamp (K75) indicates a fault following installation, use vehicle diagnostic, testing and information systemVAS 5051 A to erase and re-interrogate fault memory.]
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing Bowden cable with coupling unit for rear lid lock
- Renewing brake caliper (1KT) – Audi A1
- Dismantling and assembling drive shaft, constant velocity joint VL90/VL100
- Removing and installing upper transverse link - Audi A1 quattro
- Removing and installing lower transverse link - Audi A1 quattro
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.