Removing and installing guide: Audi A4 B6/B7

🧭 Before you start

Fits: Audi A4 B6/B7 (8E)

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Bumper removed
2. Remove bolts (1) and detach guide (2).
3. Tightening torque: 1.5 Nm — 1.5 Nm (1.1 lb-ft)
4. Clip (3) is pressed into side panel.
5. Bumper removed
6. Remove bolts (1) and detach guide (2).
7. Fastener (3) is pressed into side panel.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Checking fuel pressure regulator and holding pressure
• Removing and installing alternator, 2.0 l diesel engine, unit injector (TDI)
• Removing and installing rear left vehicle level sender G76, headlights with gas discharge lamps and cornering lights · 1 torque figures
• Removing and installing alarm horn · 1 torque figures
• Removing and installing lower part of intake manifold