Removing and installing rear left vehicle level sender G76, headlights with gas discharge lamps and cornering lights — AUDI

🧭 Before you start

Fits: VW Caddy III (2K, 2004–2015); platform code 2C0

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Switch off ignition and all electrical loads, and pull out ignition key.
2. Release and disconnect electrical connector (3).
3. Unscrew securing nut (2) and pull lower ball head out of securing clamp (1).
4. Drill out heads of the 2 pop rivets (arrows), and remove rear left vehicle level sender G76(4).
5. Remove remaining parts of pop rivets and all metal shavings caused by drilling out the pop rivets.

6. If necessary, carry out corrosion protection measures on securing holes in body General information on paintwork00Genuine products; Conservation. [Note: When installing rear left vehicle level sender G76, ensure that lever and jointed rod are in position as illustrated. Otherwise the rear left vehicle level sender G76 will supply incorrect data which causes the headlight range control to malfunction.]
7. Fit rear left vehicle level sender G76(4), and rivet it to vehicle body using 2 new pop rivets (arrows).
8. Connect and engage connector (3).
9. Align securing clamp (1) with lower edge of outer shock absorber tube, insert ball head mounting and tighten securing nut to 5 Nm. — 5 Nm (3.7 lb-ft)
10. Carry out basic setting of headlights Descriptions of work.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing turbocharger, engine codes AHF, ALH, ASV
• Removing and installing turbocharger - vehicles with four-wheel drive -engine code ASZ-
• Checking valve 2 for exhaust gas recirculation -N213
• Checking signal from high-pressure sender -G65
• Servicing front-wheel brake, brake caliper FS I - AL