Removing and installing fuse holder FSF in luggage compartment (right-side) — AUDI

🧭 Before you start

Fits: Audi A4 B8 (8K, 2007–2015)

Don't miss

• Exact contact assignment of fuse holder F in luggage compartment (right-side) can be found in applicable current flow diagram .

📋 Procedure

1. With ignition switched off, disconnect earth cable at battery .
2. Open cover in luggage compartment side trim (right-side).
3. Release retaining clips (3) in direction of (arrow) and press fuse carriers (2) out of fuse holder F towards rear.
4. Remove nut (4).
5. Guide fuse holder F (item 1) out of body.

6. Unclip fuse holders at relay carrier.
7. Pull out relay (5) and control units.
8. Release retaining clips (arrows) and press relay carrier (2) towards rear out of holder (1).
9. If fitted, cut through cable ties and remove fuse holder F. [Note: Exact contact assignment of fuse holder F in luggage compartment (right-side) can be found in applicable current flow diagram .]
10. Fit fuse holder F (item 1), making sure guides (2) are inserted properly in mountings (arrows).
11. Connect battery. Steps required .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing camshaft – Audi A6/A7 C7 · 15 torque figures
• Crankshaft - exploded view · 19 torque figures
• Securing engine to engine and gearbox support · 18 torque figures
• Exploded view - timing chain cover · 18 torque figures
• Removing and installing injection pump · 14 torque figures