Removing and installing fuse holder FSF in luggage compartment (right-side) - Sportback — AUDI

🧭 Before you start

Fits: Audi A5 (8T, 2007–2016)

Don't miss

• Exact contact assignment of fuse holder F in luggage compartment (right-side) can be found in applicable current flow diagram .

📋 Procedure

1. With ignition switched off, disconnect earth cable at battery (see the separate procedure).
2. Open cover in luggage compartment side trim (right-side).
3. Release retaining clips (3) in direction of (arrow) and press fuse carriers (2) out of fuse holder F towards rear.
4. Remove nut (4).
5. Guide fuse holder F (item 1) out of body.

6. Unclip fuse holders at relay carrier.
7. Pull out relay (5) and control units.
8. Release retaining clips (arrows) and press relay carrier (2) towards rear out of retainer (1).
9. If fitted, cut through cable ties and remove fuse holder F. [Note: Exact contact assignment of fuse holder F in luggage compartment (right-side) can be found in applicable current flow diagram .]
10. Fit fuse holder F (item 1), making sure guides (2) are inserted properly in mountings (arrows).
11. Connect battery. Steps required (see the separate procedure).

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Front axle drive and transfer box - exploded view of components
• Dismantling and assembling 1st - 3rd gear clutch -K1- with turbine shaft for gearboxes up to 11.92
• Checking accelerator position sender G79 - vehicles with 6-cylinder engine
• Removing and installing fuel delivery unit (vehicles with front-wheel drive)
• Removing and installing fuel delivery unit (vehicles with four-wheel drive)