Removing and installing fuel gauge senderG - A5 models from model year 2012 onwards, A4 models from model year 2013 onwards (vehicles with front-wheel drive) — AUDI
Removing and installing fuel gauge senderG - A5 models from model year 2012 onwards, A4 models from model year 2013 onwards (vehicles with front-wheel.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A5 (8T, 2007–2016), Audi A5 Cabriolet (8F), Audi A4 B8 (8K, 2007–2015)
Don't miss
- Risk of damage.First release retainer tabs on connector contact before detaching electrical connectors on fuel gauge senderG. — Release and unplug electrical connectors (1 ... 3).
🔧 Engine codes this applies to
📐 38 workshop diagrams for CAGA
Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.
📋 Procedure
- Observe safety precautions .
- Observe rules for cleanliness .
- Remove fuel delivery unit .
- Pull fuel gauge senderG inwards slightly and then lift out (arrows).
- If necessary, release retaining tabs (arrows) using a screwdriver.
- ⚠ Risk of damage.First release retainer tabs on connector contact before detaching electrical connectors on fuel gauge senderG. — Release and unplug electrical connectors (1 ... 3).
- Or: Unplug electrical connector on flange.
- Plug in electrical connectors (1 ... 3) and check that they have engaged properly.
- Insert fuel gauge senderG into guides on fuel delivery unit and press downwards until it clicks into place.
- Install fuel delivery unit .
Ask TorqFix about your Audi CAGA — it answers with the exact sequence for that engine and the workshop drawing for each step. First question is free after a 20-second sign-up, no card.
Ask about your Audi CAGA — free → or sign up free to see the drawingsOther AUDI procedures
- Checking fuel pressure regulating valve N276
- Removing and installing suction pipe
- Checking delivery rate of fuel pump G6 - 4-cylinder and 6-cylinder engines (generation II) and 4-cylinder EA 288 engines (generation I)
- Checking fuel system pressurisation pump G6 (electrical test) - A5 up to model year 2011, A4 up to model year 2012 (vehicles with front-wheel drive)
- Checking fuel delivery rate of fuel system pressurisation pump G6 - A5 up to model year 2011, A4 up to model year 2012 (vehicles with four-wheel drive)
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.