Removing and installing front backrest (without side airbag) — AUDI

🧭 Before you start

Fits: platform codes S1, 2H

Don't miss

• Lock washers (3) on right and left must have engaged correctly.

📋 Procedure

1. Remove front seat .
2. Remove belt buckle
3. Remove seat trims .
4. Unclip and disconnect connectors (2) from retainer (4).
5. Cut cable ties (3) and take electric wires out of seat frame (1).

6. Remove bolts (3) on right and left.
7. Prise lock washer (4) on left and right off securing pin with screwdriver.
8. Use screwdriver to detach backrest (1) from securing pins, and remove backrest (1) from seat (2).
9. Release backrest (2) from seat (1).
10. Lock washers (3) on right and left must have engaged correctly.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing camshaft control valves N208/N319, cylinder bank 2 (left-side)
• Removing and installing coolers for ATF coolant circuit, Audi RS 6/RS 7
• Removing and installing ignition coils with output stages, cylinder bank 1 (right-side)
• Removing and installing knock sensor 2G66 – Audi A1
• Removing and installing support for luggage compartment floor