Removing and installing coolers for ATF coolant circuit, Audi RS 6/RS 7 — AUDI

🧭 Before you start

Fits: Audi A6/A7 C7 (4G, 2011–2018)

• Special tools named: 3094

🔧 Engine codes this applies to

📋 Procedure

1. Remove bumper cover (front) General body repairs, exterior63Bumper (front); Removing and installing bumper cover.
2. Move coolant line clear (arrow).
3. Remove bolts (2) and nuts (3), detach air duct (1).
4. Remove nuts (arrows) and bolt (1).
5. Lift off bracket (2) and leave in position.

6. Place drip tray for workshop hoistVAS 6208 underneath.
7. Clamp off coolant hoses using hose clamps 3094, release hose clips (arrows) and disconnect hoses.
8. Detach auxiliary radiator (1) (front left).
9. Clamp off coolant hoses using hose clamps 3094, release hose clips (arrows) and disconnect hoses.
10. Detach auxiliary radiator (1) (rear left). [Note: If there are slight impressions on the fins, refer to .Secure all hose connections with the correct type of hose clips (same as original equipment) Electronic parts catalogue.The coolant in the entire system must be changed if the radiator is renewed.]
11. Install bumper cover (front) General body repairs, exterior63Bumper (front); Removing and installing bumper cover.
12. Check coolant level .

Other AUDI procedures

• Removing and installing cam actuator – Audi A6/A7 C7
• Removing and installing oil pressure switch F22/F378 – Audi
• Removing and installing coolant shut-off valve – Audi 3.0 TDI
• Removing and installing coolant pipes (bottom front)
• Removing and installing water radiator for charge air cooling circuit - Audi RS 6/RS 7
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures