Removing and installing cooler for ATF coolant circuit, Audi S6/S7 — AUDI
Removing and installing cooler for ATF coolant circuit, Audi S6/S7 on Audi: 10 steps, engines CEUC, CEUD, CRDB, CTGE.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A6/A7 C7 (4G, 2011–2018)
- Special tools named: 3094
📐 3 workshop diagrams for CEUC
Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.
📋 Procedure
- Remove noise insulation (front) General body repairs, exterior 66. Noise insulation; Removing and installing noise insulation.
- Remove front wheel housing liner (left-side) General body repairs, exterior 66. Wheel housing liners; Removing and installing front wheel housing liner.
- Remove bumper cover (front) General body repairs, exterior 63. Bumper (front); Removing and installing bumper cover.
- Detach air duct (1)(arrow).
- Place drip tray for workshop hoist VAS 6208 underneath.
- Clamp off coolant hoses using hose clamps 3094, release hose clips (arrows) and disconnect hoses.
- Remove bolts (2).
- Lift radiator (1) off bracket. [Note: If there are slight impressions on the fins, refer to .Secure all hose connections with the correct type of hose clips (same as original equipment) Electronic parts catalogue. The coolant in the entire system must be changed if the radiator is renewed.]
- Install bumper cover (front) General body repairs, exterior 63. Bumper (front); Removing and installing bumper cover.
- Check coolant level (see the separate procedure).
Ask TorqFix about your Audi CEUC — it answers with the exact sequence for that engine and the workshop drawing for each step. First question is free after a 20-second sign-up, no card.
Ask about your Audi CEUC — free → or sign up free to see the drawingsOther AUDI procedures
- Removing and installing charge air cooler housing – Audi A8 D4
- Removing and installing intake manifold (right-side) with fuel rail, cylinder bank 1
- Removing and installing secondary air pump motor V101 – Audi
- Removing and installing coolant pipe (top rear) – Audi A8 D4
- Removing and installing engine oil cooler (front) – Audi 5.0
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix → · How these pages are made →Workshop data on this page last updated 20 Sep 2026.