Removing engine from scissor-type assembly platform: Audi A6/A7 C7 (CEUA, CEUC, CEUD, CGTA, …)

🧭 Before you start

Fits: Audi A6/A7 C7 (4G, 2011–2018)

• Special tools named: VAS 6131/13

Don't miss

• Take up weight of engine with workshop hoist, but do not lift.
• Disregard (item 2).

🔧 Engine codes this applies to

📋 Procedure

1. Remove coolant pipe (top rear) .
2. Attach lifting tackle3033 to engine lifting eyes and workshop hoist as shown in illustration.
3. Take up weight of engine with workshop hoist, but do not lift.
4. Unplug electrical connectors (left and right) (1, 2).
5. Unscrew nut (right-side) (1) and detach bracket with wiring harness from subframe. [Note: Disregard (item 2).]

6. Unscrew bolt (right-side) (arrow) and detach bracket with electrical wiring harness from subframe.
7. Remove bolt (arrow) for engine mounting (left-side).
8. Remove bolt (arrow) for engine mounting (right-side).
9. Remove support VAS 6131/13-7 from engine.
10. Lift engine off engine cross member.

Other AUDI procedures

• Removing and installing intake manifold (right-side) with fuel rail, cylinder bank 1
• Removing and installing intake manifold with fuel rail, cylinder bank 2 (left-side)
• Removing and installing secondary air pump motor V101 – Audi
• Removing and installing coolant pipe (top rear) – Audi A8 D4
• Removing and installing fuel gauge sender 3 G237 (up to model year 2013)
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures