Removing and installing support for luggage compartment floor — AUDI

🧭 Before you start

Fits: Audi Q7 (4M, 2015–)

📋 Procedure

1. Remove luggage compartment floor.
2. Passenger side: If fitted, remove luggage compartment floor .
3. Fold seats (2nd row) forwards.
4. Equipment version with 5 seats: Disengage luggage compartment floor trim (1) from support for luggage compartment floor at sides (arrows) and detach.
5. Remove luggage compartment side trim .

6. Remove fastening ring .
7. Depending on equipment version: Remove retaining rail .
8. Lift support (3) for luggage compartment floor at rear, release retaining tabs (2) on support and detach sill panel trim (1).
9. Disengage support for luggage compartment floor upwards (arrows) and remove it towards rear.
10. Position support for luggage compartment floor with fastening rings/retaining rail and screw in bolts (only hand-tight).
11. Install luggage compartment floor.
12. Tighten bolts for fastening rings/retaining rail.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing rear wheel speed sensor – Audi · 3 torque figures
• Installing engine - vehicles with hybrid drive – Audi Q5 2.0 · 1 torque figures
• Adjusting pinion shaft when dimension "„E“" is marked on outer circumference of crown wheel · 3 torque figures
• Removing and installing engine cross member – Audi Q7
• Tightening torques - bracket for bevel box – Audi TT Mk2 · 5 torque figures