Tightening torques - bracket for bevel box: Audi TT Mk2

🧭 Before you start

Fits: Audi TT Mk2 (8J, 2006–2014)

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Tighten bolts in 5 stages as follows:
2. Screw in bolts (1 ... 3) (hand-tight).
3. Pre-tighten bolts (2) to 8 Nm. — 8 Nm (5.9 lb-ft)
4. Tighten bolts (1) and (3) initially to 8 Nm. — 8 Nm (5.9 lb-ft)
5. Tighten bolts (2) to 40 Nm. — 40 Nm (30 lb-ft)
6. Tighten bolts (1) and (3) to 40 Nm. — 40 Nm (30 lb-ft)
7. Tighten nuts (1) to 25 Nm. — 25 Nm (18 lb-ft)

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing radiator cowl - Audi A7 – Audi
• Removing and installing catalytic converter (left-side) - vehicles with dual clutch gearbox
• Removing and installing suspension strut (coil spring/shock absorber)
• Removing and installing bracket/hinges for centre armrest
• Checking gear oil level - gearbox with common oil system