Removing and installing front ashtray: Audi TT Mk1
Step-by-step removing and installing front ashtray for the Audi TT Mk1: 5 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi TT Mk1 (8N)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 2 Nm (1.5 lb-ft) | Unscrew bolt (1), tightening torque |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Open front ashtray.
- Unscrew bolt (1), tightening torque 2 Nm. — 2 Nm (1.5 lb-ft)
- Pull ashtray slightly forwards and down in direction of arrow at tabs (2).
- Unplug connectors (1) and (2).
- On installation, guide both rubber lugs (3) (2x) into mounts (4) (2x).
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing carrier unit
- Removing undamaged sliding window for sliding door
- Removing and installing clutch master cylinder with mounting bracket removed
- Removing and installing rear bonded rubber bush for rear final drive
- Removing and installing left side panel trim, »California Coast and Ocean«
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.