Removing and installing fresh air blower V2 - heater, manually controlled air conditioner — AUDI

🧭 Before you start

Fits: Audi A1 (8X, 2010–2018)

📋 Procedure

1. Remove glove box General body repairs, interior68Shelves / trim panels; Removing and installing glove box.
2. If fitted, remove headlight range control unit Electrical system94Automatic headlight range control; Removing and installing headlight range control unit.
3. If fitted, remove entry and start authorisation control unit Electrical system94Entry and start authorisation; Removing and installing entry and and start authorisation control unit J518.
4. Unplug electrical connector (2).
5. Remove electrical connector (1) from bracket by pressing bracket (3) in direction of (arrow A) and unplugging connector in direction of (arrow B).

6. Unplug electrical connector (6).
7. Cut through cable tie (5) and move wiring harness clear.
8. ⚠ Risk of irreparable damage to fresh air blower.If the cable tie brackets are detached from the mounting pins on the fresh air blower, the pins may break off.If the mounting pins are broken off, the fresh air blower must be renewed. — Remove bolts (arrows).
9. Unscrew bolt (4) through opening in central tube (2) with extension piece (3) and joint.
10. Pull fresh air blower (1) towards rear (as seen in direction of travel) out of air conditioning unit.
11. ⚠ Fan impeller imbalance.Do not grasp hold of the impeller of the fresh air blower V2. Applying force to the impeller or moving the balancing weights attached to the impeller could cause imbalance and thus operating problems. — Check operation of fresh air blower.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Checking fuel gauge senderG – Audi Q7
• Removing and installing fuel gauge sender 2G169, version for China
• Removing and installing activated charcoal filter - NAR vehicles
• Removing and installing non-return valve – Audi A3
• Removing and installing coolant circulation pump 2V178 – Audi