Checking fresh air and air recirculation flap control motor V154 - heater, manually controlled air conditioner — AUDI

🧭 Before you start

Fits: Audi A1 (8X, 2010–2018)

Don't miss

• If operation is not OK, check electronics in heater control unit J65/air conditioning system control unit J301 and activation of fresh air and air recirculation flap control motor V154 and .

📋 Procedure

1. Remove glove box General body repairs, interior68Shelves / trim panels; Removing and installing glove box.
2. Switch on ignition.
3. Set the rotary fresh air blower switch (2) to speed "“3”".
4. Set the rotary air distribution switch (3) to "“Dash panel vents”".
5. Fresh air/air recirculation button (5) not pressed.

6. Press the fresh air/air recirculation button.
7. Set the rotary air distribution switch to "“Windscreen”". [Note: If operation is not OK, check electronics in heater control unit J65/air conditioning system control unit J301 and activation of fresh air and air recirculation flap control motor V154 and .]
8. Dust and pollen filter for contamination
9. Forced ventilation vents for passenger compartment
10. Ingress of water into passenger compartment
11. Fresh-air intake from plenum chamber and plenum chamber water drain
12. Seals between individual components of fresh air intake and vehicle for damage and leaks
13. Activation of air conditioner compressor regulating valve N280 and operation of air conditioner Checking cooling output [Note: Under certain operating conditions, residual moisture in the refrigerant circuit may lead to the formation of ice at N280 (and at the expansion valve). Such ice formation impedes the control of the air conditioner compressor. The evaporator is cooled down too much and ices up. Icing-up of the evaporator may be the cause of the windows misting up.]

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Checking system pressure, fuel pressure regulator and residual pressure
• Removing bevel box - vehicles with diesel engine – Audi A3
• Removing and installing poly V-belt pulley for crankshaft · 1 torque figures
• Removing and installing 4/2-way valve – Audi A3
• Removing and installing telephone bracket R126 · 2 torque figures