Removing and installing fog light, vehicles as of model year 2011 — AUDI
Removing and installing fog light, vehicles as of model year 2011 on Audi: 9 steps, 1 torque figure. What to remove, what to tighten and to how many Nm.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Caddy III (2K, 2004–2015); platform code 2C0
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 1.5 Nm (1.1 lb-ft) | Screw in securing bolt (1) and tighten it |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Switch off ignition and all electrical loads, and pull out ignition key.
- Unclip cover from catches (arrow).
- Remove securing bolt (1).
- Pull fog light housing out of bumper.
- Release and disconnect electrical connector (1).
- Press fog light with tabs in (direction of arrow) into mountings in bumper.
- Screw in securing bolt (1) and tighten it to 1.5 Nm. — 1.5 Nm (1.1 lb-ft)
- Check functioning of fog light.
- Check fog light setting and adjust if necessary .
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing impact bar - vehicles with high-voltage system
- Removing and installing spoiler – Audi A3
- Removing and installing lines for clutch hydraulics – Audi A3
- Removing and installing thermostat for large cooling circuit
- Removing and installing toothed belt sprocket for coolant pump - engine code CZEA
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.