Adjusting headlight installation position, as of model year 2010 — VW
Adjusting headlight installation position, as of model year 2010 on VW: 10 steps. What to remove, in what order, and what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Golf V / Jetta (1K, 2003–2009); platform code AJ5
📋 Procedure
- ⚠ Switch off ignition and all electrical consumers.Remove ignition key. — Remove radiator grille General body repairs, exterior66Radiator grille; Assembly overview - radiator grille.
- Undo bolt (2) at rear of headlight.
- Undo screws (arrows).
- Loosen screw (arrow) at bottom of headlight.
- Adjust shut lines/flushness to body by pushing alignment bush (arrow) in or out.
- Tighten screw connections to specified torques .
- Check headlight position for uniform gaps and correct if necessary.
- Install radiator grille General body repairs, exterior66.
- Check functions of headlight.
- Check headlight settings and adjust headlights if necessary 20.1Descriptions of work.
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing air conditioner compressor poly V-belt · 3 torque figures
- Removing and installing camshaft oil seal – VW Golf VI · 2 torque figures
- Checking delivery pressure and quantity for fuel system pressurisation pump G6
- Adjusting front glass panel – VW Touareg II · 3 torque figures
- Removing and installing sun visors – VW Touareg II · 3 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.