TorqFix

Removing and installing extension for centre console: Audi A8 D3

Step-by-step removing and installing extension for centre console for the Audi A8 D3: 10 steps. What to remove, in what order, and what to check after.

Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.

10 steps

🧭 Before you start

Fits: Audi A8 D3 (4E, 2002–2010)

📋 Procedure

  1. Remove centre armrest (one-piece , split ).
  2. Remove storage compartment .
  3. Remove cup holder unit with small storage compartment lid .
  4. Move both seats to foremost position and backrests to upright position.
  5. Remove rear vent and rear Climatronic operating and display unit .
AUDI? Steps differ between engine variants — check this job against your exact car before you commit to it. Check my car — free →
  1. Remove bolts (2) (2x).
  2. Unscrew bolts (3) (6x).
  3. Remove bolts (4) (3x).
  4. Unplug connectors to sockets (2) and to large storage compartment light.
  5. Lift out extension for centre console (2) to front.

Who makes these pages, and how

TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.

The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.

Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.

Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com

The story behind TorqFix →

Workshop data on this page last updated 20 Sep 2026.