Removing and installing driver's airbag unit with sports steering wheel — AUDI
Removing and installing driver's airbag unit with sports steering wheel on Audi: 6 steps, 1 torque figure.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A2 (8Z)
Don't miss
- Always consult current safety precautions for working on airbags . — Use size T30 Torx wrench to unscrew airbag unit.
- Make sure connector -- is heard to engage.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 7 Nm (5.2 lb-ft) | Screw |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- ⚠ Always consult current safety precautions for working on airbags . — Use size T30 Torx wrench to unscrew airbag unit.
- Unplug connector --.
- Set down airbag unit with impact cushion facing upwards.
- Make sure connector -- is heard to engage.
- Screw on (7 Nm) airbag unit. — 7 Nm (5.2 lb-ft)
- ⚠ Make sure there is no-one in the vehicle. — Switch on ignition and connect battery earth strap. [Note: After connecting battery, remember to check vehicle equipment (radio, clock, electric window lifters,...). 27If airbag warning lamp (K75) indicates a fault following installation, use vehicle diagnostic, testing and information systemVAS 5051 A to erase and re-interrogate fault memory.]
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing multifunction buttons - 3-spoke steering wheel (from model year 2013 onwards)
- Removing and installing rear side panel (top) without tank flap unit
- Adjusting front lid
- Removing and installing seat pan cover and padding (seats with manual or electric adjustment)
- Checking and adjusting selector lever cable - vehicles up to 11.2009
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.