Removing and installing airbag unit (driver side) on vehicles with sports steering wheel — AUDI

🧭 Before you start

Fits: Audi A6 C5 (4B)

Don't miss

• Make sure connector -- engages audibly.

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. ⚠ Observe safety regulations for working on airbags . — Use Torx wrench (size T30) to unscrew airbag unit.
2. Unplug electrical connector --.
3. Set down airbag unit with impact cushion facing upwards.
4. Make sure connector -- engages audibly.
5. Bolt on airbag unit (7 Nm). — 7 Nm (5.2 lb-ft)
6. ⚠ Make sure there is no one in the vehicle. — Switch on ignition and connect battery earth strap. [Note: After connecting battery, remember to check vehicle equipment (radio, clock, electric window regulators) according to Workshop Manual and/or Owner's Manual.If airbag warning lamp (K75) indicates a fault following installation, use vehicle diagnostic, testing and information systemVAS 5051 A to erase and re-interrogate fault memory.]

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Dismantling and assembling selector shaft
• Removing and installing particulate filter, Crafter 4MOTION with Achleitner four-wheel drive
• Removing and installing wheel arch trim - right load bed
• Removing and installing front door trim, version B
• Removing and installing rear floor covering, single cab