Removing and installing door hinges: Audi A6 C5

🧭 Before you start

Fits: Audi A6 C5 (4B)

Don't miss

• Door hinge (2) can also be detached (23 Nm) by way of stud bolt (4).

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Unscrew (30 Nm) bolt (3) to remove door shell. [Note: Door hinge (2) can also be detached (23 Nm) by way of stud bolt (4).] — 30 Nm (22 lb-ft)
2. To remove door hinge (2), additionally unscrew (30 Nm) bolts (1) (2x). — 30 Nm (22 lb-ft)
3. Unscrew (30 Nm) bolts (3) to remove door shell. — 30 Nm (22 lb-ft)
4. To remove door hinge (2), additionally unscrew (30 Nm) bolts (1) (2x). — 30 Nm (22 lb-ft)
5. Coat lubrication points (arrows) with greaseG 000 150.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing starter - vehicles with 5.2 ltr. FSI engine from model year 2013 onwards
• Removing and installing exterior mirror turn signal bulb L131/L132 - R8 GT
• Removing and installing connector point (rear right) - R8 Spyder
• Removing and installing bracket for fuse holder (rear right) - R8 Coupé
• Removing and installing clutch slave cylinder with release bearing - manual gearbox