Removing and installing starter - vehicles with 5.2 ltr. FSI engine from model year 2013 onwards — AUDI

🧭 Before you start

Fits: platform code 42

Don't miss

• B+ wire can only be disconnected after unplugging connector for terminal 50.
• Check whether aluminium bolts can be reused; if so, apply marking .

📋 Procedure

1. With ignition switched off, disconnect earth cable at battery .
2. Remove combination valve for secondary air (left-side) 26.
3. Remove cap (2).
4. Unplug connector (4) by sliding locking element to rear and pressing down release mechanism. [Note: B+ wire can only be disconnected after unplugging connector for terminal 50.]
5. Unscrew nut (3) and detach B+ wire from solenoid switch.

6. Unscrew bolts (arrows).
7. Press starter (1) upwards off gearbox.
8. Detach starter.
9. Check whether aluminium bolts can be reused; if so, apply marking .
10. Install combination valve for secondary air (left-side) 26.
11. Connect battery. Steps required .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing propshaft, Audi A4
• Removing and installing ABS control unit J104/ABS hydraulic unit N55, Audi S1
• Removing and installing brake pads (1KT) – Audi A1
• Removing and installing wheel bearing housing - Audi S1 – Audi
• Removing and installing trailing arm with mounting bracket - Audi A1 quattro