Removing and installing exterior mirror turn signal bulb L131/L132 - R8 GT — AUDI

🧭 Before you start

Fits: platform code 42

Don't miss

• Risk of paintwork damage.Mask the area around the exterior mirror housing with a soft cloth. — Remove locking bolt (2).
• Entire turn signal in exterior mirror must be renewed as a complete unit if an LED is defective.

📋 Procedure

1. Remove mirror adjustment unit 66.
2. ⚠ Risk of paintwork damage.Mask the area around the exterior mirror housing with a soft cloth. — Remove locking bolt (2).
3. Turn housing (3) slightly to front (arrow A) and lift off mirror base (1).
4. Remove bolts (arrows A).
5. Remove mounting plate (4) from housing (1).

6. Unplug electrical connector at turn signal repeater.
7. Detach mounting plate and guide electrical connectors (2, 3) through opening (arrow B).
8. Detach mounting plate and exterior mirror housing.
9. Remove bolts (arrows).
10. Take turn signal bulb (2) out of exterior mirror housing (1). [Note: Entire turn signal in exterior mirror must be renewed as a complete unit if an LED is defective.]
11. Install exterior mirror housing and mounting plate 66.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Dismantling and assembling input shaft, output shafts (pinion shafts), differential, bevel box and selector rods - gearboxes from approx. 04.2003
• Sealing flanges and dual-mass flywheel/drive plate - exploded view of components
• Connecting up vehicle diagnostic, testing and information system VAS 5051 A and selecting functions
• Adaption of clutch characteristic curve
• Removing and installing subframe - Audi S3