TorqFix

Removing and installing dash panel insert with control unit in dash panel insert J285 - dash panel insert low/midi — AUDI

Removing and installing dash panel insert with control unit in dash panel insert J285 - dash panel insert low/midi on Audi: 12 steps.

Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.

12 steps

🧭 Before you start

Fits: Audi A4 B9 (8W, 2015–)

Don't miss

  • Protective cap prevents contamination of or mechanical damage to end face of fibre optic cable which would impair light transmission.

📋 Procedure

  1. Move steering wheel down and to rear as far as possible, making use of full range of steering column adjuster.
  2. Switch off ignition and store ignition key outside of vehicle.
  3. Remove dash panel vent (left and right) General body repairs, interior70Dash panel; Removing and installing dash panel vent.
  4. Remove bolt (2).
  5. Detach trim for dash panel insert (1).
AUDI? Steps differ between engine variants — check this job against your exact car before you commit to it. Check my car — free →
  1. Remove bolts (1, 4).
  2. Insert hook T40207 between dash panel and dash panel insert and engage in centre (3), as shown.
  3. Pull dash panel insert (2) out of catch (arrow) using hook T40207 and swivel towards rear.
  4. Unplug electrical connector (1).
  5. Dash panel insert midi: Unplug connector (2) for fibre optic cable.
  6. Seal open connector plug (2) of fibre optic cable with protective cap for cable connectorVAS 6223/9(item 1). [Note: Protective cap prevents contamination of or mechanical damage to end face of fibre optic cable which would impair light transmission.]
  7. Take out dash panel insert towards front passenger side between steering wheel and dash panel.

Who makes these pages, and how

TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.

The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.

Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.

Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com

The story behind TorqFix →

Workshop data on this page last updated 20 Sep 2026.