Installing dash panel insert — AUDI
Installing dash panel insert on Audi: 11 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform codes 70A, 7DA
📋 Procedure
- Insert dash panel insert into dash panel insert aperture and reconnect connections.
- Secure wiring harness for blue multi-pin connector (32-pin) to back of dash panel insert using clamp - arrow.
- Perform remainder of installation in opposite sequence to removal sequence.
- After completing installation, check function of dash panel insert.
- Code dash panel insert Electrical system, self-diagnosis01Self-diagnosis of the dash panel insert with no data bus connection.
- Adapt odometer display Electrical system, self-diagnosis01Self-diagnosis of the dash panel insert with no data bus connection.
- Adapt service interval data Electrical system, self-diagnosis01Self-diagnosis of the dash panel insert with no data bus connection.
- Code dash panel insert Electrical system, self-diagnosis01Self-diagnosis of the dash panel insert with data bus connection.
- Coding diagnostic interface for data bus, only for dash panel inserts with data BUS connection Electrical system, self-diagnosis01Self-diagnosis of the dash panel insert with data bus connection
- Adapt odometer display Electrical system, self-diagnosis01Self-diagnosis of the dash panel insert with data bus connection.
- Adapt service interval data Electrical system, self-diagnosis01Self-diagnosis of the dash panel insert with data bus connection.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing rear right side panel trim, »California Coast and Ocean«
- Checking non-return valve and vacuum hoses to valves N125 and N126
- Removing and installing air compressor V534 and pressure accumulator
- Assembling layshaft
- Removing and installing injector for reduction agent N474 · 1 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.