Removing and installing cooler for fuel cooling system - vehicles with engine code BTR/CCFA — AUDI

🧭 Before you start

Fits: Audi Q7 (4L, 2005–2015)

Don't miss

• Secure all hose connections with the correct type of hose clips (same as original equipment) Electronic parts catalogue.

🔧 Engine codes this applies to

📋 Procedure

1. Activate jacking mode 43.
2. Take cover (2) out of guide in lock carrier (1)(arrows A).
3. Detach cover from side section of bumper cover and from radiator grille (arrows B).
4. Remove front noise insulation (1)66.
5. Unscrew bolts (arrows) and remove air ducts (left and right).

6. Remove bolts (2 ... 5).
7. Place drip tray for workshop hoistVAS 6208 beneath engine.
8. Use hose clamps 3094 to clamp off coolant hoses (1) and (6) and disconnect hoses from cooler for fuel cooling system. [Note: Secure all hose connections with the correct type of hose clips (same as original equipment) Electronic parts catalogue.]
9. Install air ducts 50.
10. Fill up with coolant .

Other AUDI procedures

• Audi 4.1 TDI gearbox removal & installation · 2 torque figures
• Removing and installing toothed belt for high-pressure pump · 3 torque figures
• Removing and installing exhaust manifold (left-side) – Audi · 4 torque figures
• Removing and installing exhaust gas temperature sender 1G235 · 1 torque figures
• Removing and installing turbocharger (right-side) – Audi A8 D3 · 1 torque figures
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures