Removing and installing water radiator for fuel cooling system - vehicles with engine code letters AJM — AUDI

🧭 Before you start

Fits: Audi A6 C5 (4B)

• Opens: coolant

🔧 Engine codes this applies to

📐 9 workshop diagrams for AJM

Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.

📋 Procedure

1. Unscrew bolts (arrows).
2. Remove air ducts (1) and (2).
3. Remove front bumper General body repairs, exterior63.
4. Clamp off coolant hoses to water radiator for fuel cooling system with hose clamps3094.
5. Place drip trayV.A.G 1306 or drip trayVAS 6208 under engine.

6. Detach top coolant hose (1).
7. Disconnect bottom coolant hose (2) from water radiator for fuel cooling system (1).
8. Unscrew bolt (3) for fuel cooling pump.
9. Detach water radiator for fuel cooling system.
10. Install front bumper General body repairs, exterior63.
11. Fill cooling system .

Other AUDI procedures

• Tightening torques
• Removing and installing ribbed belt
• Ribbed belt drive for vane pump, alternator and viscous fan
• Checking intake manifold pressure sender -G71 and elevation sender -F96
• Check intake manifold pressure sender -G71
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures