Removing and installing chain/chain tensioner for oil pump - "“engine generation III”" — AUDI

🧭 Before you start

Fits: Audi A4 B5 (8D)

🔧 Engine codes this applies to

📋 Procedure

1. Remove sump (bottom section) .
2. Remove sealing flange (front) .
3. Place used oil collection and extraction unitV.A.G 1782 under engine.
4. Unbolt brackets (arrows) and pull off long oil supply pipe from below.
5. Unscrew chain sprocket using TORX wrench T45 (arrow) and pull it off oil pump.

6. Take chain sprocket out of chain.
7. Pull off chain tensioner.
8. Lift off chain.
9. Install sump (bottom section) Installing sump (bottom section) - engines with moulded gasket or Installing sump (bottom section) - engines with liquid gasket.
10. Install sealing flange (front) .

Other AUDI procedures

• Checking hydraulic bucket tappets – Audi A6 C5
• Removing and installing left exhaust manifold – Audi A8 D2
• Removing and installing right front exhaust pipe with catalytic converter
• Checking chain tensioner for oil pump and removing and installing oil pump
• Testing fuel pump relay -J17 and activation
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures