Removing and installing brackets for control motors V109 / V111, "“basic”" version — AUDI

🧭 Before you start

Fits: Audi A6/A7 C7 (4G, 2011–2018); platform code 4X

📋 Procedure

1. Remove the right centre vent control motor .
2. Remove the right footwell flap control motor .
3. Move electrical wiring harness (8) clear.
4. Remove bolts (1, 3, 6 and 7).
5. Detach bracket (5). This may release cam plates with levers (2 and 4) at air distribution housing.

6. Check the connecting elements and actuating arms for the various flaps for proper operation and correct installation position.
7. Insert wiring harness in mounting, making sure that it cannot come into contact with moving components (e.g. control motor lever).
8. Fit the right footwell flap control motor .
9. Fit the right centre vent control motor .
10. Read out event memory and delete any entries displayed.
11. Perform basic setting.
12. Perform final control diagnosis.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing operating and display unit, Climatronic control unit J255
• Removing and installing compressor (vehicles with 4 or 6-cyl. engine)
• Removing and installing MiniDisc player R153 – Audi A6 C6
• Removing and installing chip card reader control unit J676
• Removing and installing voice control system (from week 36/08 onwards)