Removing and installing brackets for control motors V110 / V299, "“deluxe”" version — AUDI

🧭 Before you start

Fits: Audi A6/A7 C7 (4G, 2011–2018); platform code 4X

📋 Procedure

1. Remove defroster flap control motor .
2. Remove the left side vent control motor .
3. Remove the left centre vent control motor .
4. Lay bare the wiring harness (C).
5. Remove bolts (B).

6. Detach bracket (A).
7. Check the connecting elements and actuating arms to the various flaps (A), (B) and (C) for proper operation and correct installation position.
8. Insert wiring harness in mounting, making sure that it cannot come into contact with moving components (e.g. control motor lever).
9. Fit the left centre vent control motor .
10. Fit the left side vent control motor .
11. Install defroster flap control motor .
12. Read out event memory and delete any entries displayed.
13. Perform basic setting.
14. Perform final control diagnosis.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing fuel gauge sender 3G237 – Audi A6 C5
• Vehicles with 4-cylinder engine (unit injector)
• Removing and installing thermostat housing with map-controlled engine cooling thermostat F265
• Checking variable valve timing when driving – Audi A6 C5 3.0
• Checking exhaust flap 1 valve N321 – Audi A6 C5 3.0