Removing and installing brackets for control motors V111 / V213, "“deluxe”" version — AUDI

🧭 Before you start

Fits: Audi A6/A7 C7 (4G, 2011–2018); platform code 4X

📋 Procedure

1. Remove the indirect ventilation flap control motor .
2. Remove the right centre vent control motor .
3. Remove bolts (1, 3, 4 and 6).
4. Move electrical wiring harness (5) clear.
5. Detach bracket (2).

6. Move the toothed segment (A) of the lever for the indirect ventilation flap and the actuating arm (B) to the position shown.
7. Check the connecting elements (C, E) and actuating arm (D) for the various flaps for proper operation and correct installation position.
8. Insert wiring harness in mounting, making sure that it cannot come into contact with moving components (e.g. control motor lever).
9. Fit the right centre vent control motor .
10. Fit the indirect ventilation flap control motor .
11. Read out event memory and delete any entries displayed.
12. Perform basic setting.
13. Perform final control diagnosis.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing left stub shaft, 5-speed manual gearbox
• Removing and installing voltage regulator · 1 torque figures
• Removing and installing airbag unit on driver side
• Removing and installing airbag unit on driver side (multifunction)
• Removing and installing front door trim, driver side