Removing and installing belt guide (rear right and left) — AUDI

🧭 Before you start

Fits: Audi A4 B6/B7 (8E)

Don't miss

• When installing belt guide (1), make sure both washers (3) are beneath belt guide.

📋 Procedure

1. Remove side padding .
2. Remove C-pillar trim .
3. Remove three-point seat belt (rear) .
4. If fitted, take foam pad (4) out of bottom part of guide.
5. Working from underneath, slacken both cross-head bolts (2).

6. Detach belt guide (1).
7. When installing belt guide (1), make sure both washers (3) are beneath belt guide.
8. Press belt guide into fastener so that retaining tab (5) engages audibly.
9. Screw cross-head bolts (2) back in again.
10. Re-insert foam pad (4) into belt guide (1).
11. Re-install all other components removed earlier.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Renewing cables for sunroof sun blind – Audi Q3
• Removing and installing motor for sunroof sun blind – Audi
• Removing and installing trim panel for B-pillar (rear door)
• Removing and installing exterior mirror housing – Audi TT Mk2
• Removing and installing centre three-point seat belt (rear)